A transect of wells is established on the marsh platform, perpendicular to the marsh edge. A total of 5 wells are dug to the depth of the water table under the marsh platform. Wells 1-4 are spaced approximately evenly within the first 6m of marsh edge with well 5 approximately 20m upland from the marsh edge. A water level logger, referred to as the tide gauge, (Onset HOBO U20 series) is placed at the river bottom directly in front of the transect . Individual water level loggers (Onset HOBO U20 series) are used in each well and they measure water height in terms of absolute pressure. Barometric pressure is measured above ground with an additional Onset HOBO U20 series water level logger to tease out the atmospheric pressure from water column pressure. Prior to deployment, each water level logger is sealed in protective plastic whirl-pak bags filled with freshwater, and calibrated to known water depths. Once in the field, water height measurements, in terms of absolute pressure, are recorded every 10 minutes. Pressure readings are uploaded from the HOBO water level loggers using HOBOware software which compensates for temperature, fluid density, and barometric pressure, then are converted to absolute water height above the river bottom. Well Location Information: Logger Well Height of Marsh Surface Above Creek Bottom (m) orizontal Distance Upland of Creek Edge (m) 1 (tide gauge) 0 -10.68 2 1 3.04 0.57 3 2 3.20 1.62 4 3 3.25 3.06 5 4 3.31 5.15 6 5 3.32 19.82 Logger 1 tide gauge located on river bottom. Marsh wells 1-5, numbered consecutively moving upland. NOTES AND COMMENTS: Due to occasional equipment malfunction, readings are not continuous throughout the field season. Times in EST.