RLS water level install,IBYC, 9/20/11 Hap Garritt, Sam Kelsey(MBL) Nichole Halsey, RonanO’Maitu (Hach)

Used Growler boat at high tide to attach 2 x 6 pressure treated wood underneath pier platform between pilings. Wood will be used to attach the RLS. Wood attached with concrete adhesive and concrete screws. RLS attached to wood with screws and leveled with shingle shims. RLS cable attached to 2x4 wood which was secured along concrete. Cable attached to eye screws using cable ties.

Measured distances

Pier deck to sediment bottom, deck near logger down to bottom by floating dock directly downstream of logger/deck railing = 22.45 ft or 6.84 meters

RLS height above pier deck = 33 inches or 0.838 meters
IBYC NAVD88 benchmark/pier deck by datalogger = 2.78 meters, as determined by Trimble high precision GPS.
2010 2.773
2009 2.811
2008 2.779
2007 2.780

Calculated distances RLS to sediment bottom = 6.84 + .838 = 7.68 meters
RLS relative to NAVD88 = 3.618 meters

The OTT RLS sensor technology is based on impulse radar. Two antennas are enclosed in a compact housing and transmit pulses toward the water surface, through a Teflon face plate. The transmitting antenna transmits short radar pulses in the 24 GHz ISM band. The receiving antenna receives the pulses reflected from the water surface to determine the distance between the face plate of the radar sensor and the water surface. The time delay from transmission to receipt is proportional to the distance between sensor and water surface. Approximately 16 individual measurements are conducted per second and averaged after 20 seconds to minimize wave influences.

There may be sporadic instances of no data (documented in Comments field of the data) due primarily to low battery voltage over several days causing the datalogger to malfunction.